DMP Thinline Keypad Help

Thinline-WhtQuickKeys082008B

Panels:  
XR150/350 XT30/50
Keypads:
7060,7063, 9060-W
Arm: Press the COMMAND key until ARM DISARM displays. Select ARM to turn on all protection. Enter your user code if required. The display reads ALL? NO YES. Select YES to arm all areas authorized for your user code.

Disarm: Press the COMMAND key until ARM DISARM displays. Select DISARM to disarm areas. The keypad displays ENTER CODE:. Enter your user code and press COMMAND. The keypad displays ALL? NO YES. Select YES to disarm all areas authorized for your user code.

Bypass Zone(s): If a problem exists on any zones, the zone name and problem are shown followed by: OKAY BYPASS STOP. Select BYPASS to bypass the zone(s) before arming.

Smoke Reset: Access the User Menu. When SENSOR RESET? displays, press any Select key. The keypad displays SENSORS OFF for five seconds followed by SENSORS ON. The keypad returns to the status display.

– Shortcut: Press 2 for 2 seconds, then enter your user code if required, to reset the system.

Chime Mode On/Off: You can use the Monitor (Chime), shortcut key 5, when the system is disarmed. When pressed, the Zone Monitor operation is initiated. As needed, refer to the Zone Monitor section. The keypad displays MONITOR ON and chimes or displays MONITOR OFF and no tone is sounded.